Delta Electronics — 11.3.2 Interpolation Position Mode

ASDA-B3 CANopen Mode Adjustment method: It is suggested to set the SYNC communication cycle (OD 1006h) between 1 ms and 10 ms. Since the cycle time is too long, the position error also increases. If the position change is big, 11 it causes speed fluctuations. In this case, use P1.036 (S-curve acceleration / deceleration constant) or P1.068 (Position command - moving filter) to smooth the position difference. Since the jitter of each controller is different, the servo receives a difference between the SYNC and SYNC communication cycle time.

When this happens, adjust the error value (U) of P3.009 to increase the error range and let the servo drive automatically correct the internal timer so it is consistent with the communication cycle of the controller. Relevant object list Note: for more details, refer to Section 11.4.3 Details of objects. 11-23 Index Name Data type Access Controlword UNSIGNED16 Statusword UNSIGNED16 Modes of operation INTEGER8 Modes of operation display INTEGER8 Position factor UNSIGNED32 Interpolation sub mode select INTEGER16 Interpolation data record INTEGER32