Delta Electronics — Communication type

Troubleshooting ASDA-B3 Communication type 12 Note: if the servo drive shows an alarm that is not in this table, contact the local distributor or technician.

12-6 Error type Servo state Display Alarm name ALM WARN ON OFF AL111 Buffer overflow occurs when receiving SDO ○ ○ AL112 Buffer overflow occurs when receiving PDO ○ ○ AL121 Object’s index does not exist when accessing PDO ○ ○ AL122 Object’s sub-index does not exist when accessing PDO ○ ○ AL123 Data length error occurs when accessing PDO ○ ○ AL124 Data range error occurs when accessing PDO ○ ○ AL125 PDO object is read-only and write-protected ○ ○ AL126 Specified objects does not support PDO mapping ○ ○ AL127 PDO object is write-protected when servo drive is on ○ ○ AL128 Error occurs when PDO object is read from EEPROM ○ ○ AL129 Error occurs when PDO object is written to EEPROM ○ ○ AL130 Accessing address of EEPROM is out of range ○ ○ AL131 EEPROM CRC calculation error ○ ○ AL132 Parameter is write-prohibited ○ ○ AL170 Bus communication timeout ○ ○ AL180 Bus communication timeout ○ ○ AL185 Bus hardware error ○ ○ AL186 Bus data transmission error ○ ○ AL201 Initialization error of objects or data array ○ ○ AL301 CANopen synchronization failure ○ ○ AL302 Synchronization signal of CANopen is sent too soon ○ ○ AL303 CANopen synchronization signal timeout ○ ○ AL304 IP mode command failure ○ ○ AL305 SYNC period error ○ ○ AL3E1 Communication synchronization fails ○ ○ AL3E2 Communication synchronization signal is sent too soon ○ ○ AL3E3 Communication synchronization signal timeout ○ ○ AL401 NMT reset command is received when servo is on ○ ○