Delta Electronics — 12.2 Causes and corrective actions

Troubleshooting ASDA-B3 12 12-16 AL022 RST leak phase Trigger condition and cause Condition: RST power cable is loose or there is no power. The error type of AL022 is a warning by default. To set AL022 as an alarm, you can set P2.066 [Bit 12] to 1. Cause: RST leak phase. Checking method and corrective action Check if the RST power cable is loose or there is no power. For 1.5 kW (or below) ASDA-B3 servo drives, this alarm occurs when all three phases are not connected to the power supply. For 2 kW (or above) ASDA-B3 servo drives, this alarm occurs when one single phase is not connected to the power supply. Correctly connect the power to the servo drive.

If the issue persists, send your servo drive back to the distributor or contact Delta. How to clear the alarm? DI.ARST AL023 Early overload warning Trigger condition and cause Early overload warning. Checking method and corrective action 1. Check if your servo drive is overloaded and refer to the corrective actions for AL006 for troubleshooting. 2. Check if the value of P1.056 (Motor output overload warning level) is set too low. If so, increase the value, which should be over 100 to disable the warning function. How to clear the alarm? DI.ARST AL024 Encoder initial magnetic field error Trigger condition and cause Condition: the magnetic field of the encoder U, V, W signal is in error.

Cause: the initial magnetic field of the encoder is in error. (Signal U, V, W of the encoder magnetic field is in error.) Checking method and corrective action 1. Check if the motor is properly grounded. Make sure the power cable (green end) is grounded to the servo drive heat sink. 2. Check if the connection for the encoder signal cable is normal. Make sure the encoder signal cable is separated from the power supply or any high-current cables to avoid interference. 3. Use shielded cable for the encoder. If the issue persists, send your servo motor back to the distributor or contact Delta. How to clear the alarm? Cycle power on the servo drive.