ASDA-B3 Troubleshooting AL131 EEPROM CRC calculation error The data in ROM is damaged. All objects are automatically restored to default Trigger condition and cause values. 12 Checking method and corrective action Check if the specified object causes a CRC calculation error in EEPROM when the servo drive receives or sends PDO. Usually, this alarm is caused by an error in DSP. How to clear the alarm? NMT: reset node, 0x6040 fault reset, or DI.ARST. 12-37 AL132 Parameter is write-prohibited Trigger condition and cause When using bus communication to write data to the parameter, the parameter is currently write-prohibited.
Checking method and corrective action Refer to the specified parameter description to write data to the parameter. How to clear the alarm? NMT: reset node, 0x6040 fault reset, or DI.ARST. AL170 Bus communication timeout Trigger condition and cause The servo drive does not receive any PDO data within the set communication cycle time. Checking method and corrective action 1. Check if the communication is normal. 2. Check if the wiring is correctly connected. How to clear the alarm? NMT: reset node, 0x6040 fault reset, or DI.ARST. AL180 Bus communication timeout Trigger condition and cause The servo drive does not receive any PDO data within the set communication cycle time.
Checking method and corrective action 1. Check if the communication is normal. 2. Check if the wiring is correctly connected. How to clear the alarm? NMT: reset node, 0x6040 fault reset, or DI.ARST.