3. HARDWARE SETUP 10) Floppy Disk Drive Connector (34-1 pin FLOPPY) This connector supports the provided floppy drive ribbon cable. After connect- ing the single end to the board, connect the two plugs on the other end to the floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta- tion when using ribbon cables with pin 5 plugged). NOTE: Orient the red markings on the floppy ribbon cable to PIN 1 PIN 1 Connectors 3. H/W SETUP CUV4X Floppy Disk Drive Connector 11) Chassis Intrusion Lead (2 pin CHASSIS) This requires an external detection mechanism such as a chassis intrusion moni- tor/sensor or microswitch.
The sensor is triggered when a high level signal is sent to the Chassis Signal lead, which occurs when a panel switch or light detec- tor is triggered. If the chassis intrusion lead is not used, a jumper cap must be placed over the pins to close the circuit. CUV4X CHASSIS CUV4X Chassis Open Alarm Lead 34 ASUS CUV4X User’s Manual CUV4X