3. HARDWARE SETUP 12) Wake-On-LAN Connector (3-pin WOL_CON) This connector connects to a LAN card with a Wake-On-LAN output, such as the ASUS PCI-L101 Ethernet card (see 7. Appendix ). The connector powers up the system when a wakeup packet or signal is received through the LAN card. IMPORTANT: This feature requires that Wake-On-LAN features are enabled (see 4.4.3 Power Management ) and that y our system has an ATX power supply with at least 720mA +5V standby power. IMPORTANT: Requires an ATX power supply with at least 720mA +5 volt standby power. WOL_CON +5 Volt Standby PME Ground Connectors 3.
H/W SETUP CUV4X Wake-On-LAN Connector 13) Wake-On-Ring Connector (2-pin WOR) This connector connects to internal modem cards with a Wake-On-Ring output. The connector powers up the system when a ringup packet or signal is received through the internal modem card. NOTE: For external modems, Wake-On-Ring is detected through the COM port. IMPORTANT: This feature requires that Wake-On-Ring features are enabled (see 4.4.3 Power Management ) and that your system has an ATX power supply with at least 720mA +5V standby power. WOR RI# Ground 2 1 CUV4X Wake-On-Ring Connector ASUS CUV4X User’s Manual 35 CUV4X CUV4X