AREA 51 OPERATOR'S fs MANUAL eer tery DRIVE _ BUSY (YELLOW — located near the hard disk cable) “% CHAPTER Meaning 3 — TROUBLESHOOTING AND MAINTENANCE Action Flashing intermittently Normal Continuously OFF Hard Disk not reading Check the cables connected to the disk Continuously ON Hard Disk Error Check the cables connected to the disk Program WatchDog (GREEN — located near the four ROM Continuously ON Normal Blinking ROM problem POWER (GREEN — located near the JAMMA Continuously ON chips on the top board) Check the program EPROM connector) Normal No power is reaching the board Continuously OFF Check the power supply and cables TOO LOW (RED — located next to the power LED) Continuously ON Power supply voltage too low TOO_HIGH Adjust the power supply, as explained in the Repair Procedures (RED — located next to the power LED) Power supply voltage too high Continuously ON Table 3-2 1.
2. If the TOO_HIGH Adjust the power supply, as explained in the Repair Procedures LED Indicators Troubleshooting LED is on, skip to step 2. Otherwise, slowly raise the voltage until the TOO_HIGH turns on. LED Slowly lower the voltage until the TOO_HIGH LED turns off, 1. Remove the four retaining screws securing the rear door. 2. Unlock the rear door of the cabinet and remove 3. Disconnect the wiring harnesses from it. the power supply. Power Supply — Replacement A for bent pins The power supply provides power to all of the game assemblies that require it. 4. it. 5. Unfasten the two screws that secure the power supply assembly to the cabinet, and remove the power supply assembly. 6.
Re-install the power supply assembly by following the previous steps in the reverse order. NOTE The power supply has no user-serviceable parts. Call your distributor for advance Unfasten the two screws securing the top bracket and remove replacement. Return the power supply in an ROMs approved shipping container. a Failure of the power supply may result in erratic game play or no power at all. If this is the case, repair or replace the power supply assembly by following the steps below. The ROMs contain the programming routines used by the game PCB set to control game play. Replace the damaged ROMs by following the removal and installation steps below. 1.
WARNING The power supply can contain high voltages even after the power switch is turned off. To avoid injury, observe all of the safety precautions before working on the power supply. (Refer to the Introduction in the Maintenance Procedures section.) Remove the game PCB set according to the procedure in the Area 51 Game PCB Set section. CAUTION Before handling static-sensitive components, properly ground yourself to discharge buildup of static charges. 3-5