CHAPTER 3 ~ TROUBLESHOOTING dey) aii} AND MAINTENANCE & 51 OPERATOR’S MANUAL Suggested Action Problem Wns Coin Mechanism Check the wiring connections to the coin mechanism. Check the voltage to the + side of the mechanism. Test the coin mechanism with the Controls Test screen in the self-test. Problem ok WM Gun AREA Check gun lens for dirt or blockage. Test the gun with the Gun Test screen in the self-test. Check the harnesses and connectors. If you took the gun apart, have you reassembied it correctly? Make sure all the parts of the gun are in good order. Repair or replace parts as needed. Check to see if any bright lights in the game area are interfering with gun operation.
Sound Problem 1. 2. 3. Video Check the speaker volume setting: make sure the volume isn't zero! Test the sound with the Sound Test screen in the self-test. Check the resistance of the speaker for 4 Ohms. Display Problem NOahRWN + Screen is dark Check to see that the game is plugged in and powered on. Check the line fuse if no power is present. Check the display brightness. Check the edge connector to the PCB. Check the harnesses and connectors to the video display PCB. Check the voltage levels to the video display PCB. Run through the following checklist. If you answer no to any question, you have a problem with the video display, not with the game circuitry.
In this case, refer to your video display service manual, a. b. c. N- Only a colored screen appears at Attempt to run a complete memory test in the self-test. Replace the ROM if a ROM failure is reported in the self-test. Check the voltage levels to the video display PCB. RQ Picture wavers or is too small Do you have power to the video display? Are the video display’s filaments {it? Do you have the correct voltage to the video display? Check the B+ to the video display. (Refer to the video display manual.) Picture is wavy 1. 2. Check the connection of the monitor ground wire to the monitor. Check the connections of the sync inputs. Picture is upside down or reversed 1.
If you replaced the monitor recently, check the horizontal or vertical yoke wire connections to the video display. They may be switched. purity or color problems No Convergence, Picture is not centered 1. Use the self-test mode to digitally adjust the video display. Use the adjustment procedures in your video display manual. Use the centering procedures in your video display manual. Table 3-1 General Troubleshooting