AREA replace the speaker using the removal steps below. 1. 51 OPERATOR’S and installation MANUAL 1. Remove door. Disconnect the harness from the speaker. 4. Replace and reinstall the speaker in reverse order. set. (There are 5 connectors it. in all.) CAUTION Before handling static-sensitive compo- Use the light access door located on the top rear of the cabinet to replace the attraction panel light bulb. 1. Remove the two screws securing the light access door. 2. Unlock the access door and remove it. 3. Remove the cardboard bulb retaining clips one at a time by pressing on the circular tab and pulling the clip out. 4. Remove the upwards.
pushing nents, properly ground yourself to discharge buildup of static charges. 4, Unfasten the three screws and spacers that secure the game PCB set to the electronics tray. Remove the game PCB set (refer to Figure 4-4.) 5. Re-install the game PCB set by following the previous steps in the reverse order. it Hard Disk Drive Guns 0 CAUTION CAUTION while the power is on can damage the PCB. Open the upper coin door. 2. Disconnect the gun wire connector from the wiring harness. 1. Disconnect the ribbon and power cables from the disk drive. 2. Remove the four mounting screws that secure the disk drive to the mounting bracket.
Unfasten the the three flat washers and nuts that secure the gun cable mount. Use the self test to calibrate the guns after installation. System Logic Assemblies This section describes the repair and maintenance procedures for the assemblies and components that are related to the system’s logic and electronics, including the printedcircuit boards (PCBs) and the power supply. These components are mounted on the electronics tray and are accessed by opening the rear door. ' Area 51 Game PCB Set 0 The Area 51 game PCB set (board stack) is responsible for the display graphics and game play. Failure of the game PCB set may result in erratic or no game play.
If this is the case, repair or replace the game and Handle with Care! The hard disk drive can be damaged by a strong impact. Handle it gently to prevent damage. The hard disk drive can also be damaged by electrostatic discharge. Use the same precautions as used for the PCB. Unplugging the guns from the wiring harness 1. The hard disk drive unit stores the sound graphics information for the game program. To detach the gun and its cable for repair or replacement, use the following steps. 3. MAINTENANCE Disconnect the harness connectors from the game PCB Attraction Panel Light Bulb it and AND the four retaining screws securing the rear Unlock the rear door and remove 3.
3, rotating 3 — TROUBLESHOOTING PCB set by following the removal and installation steps Remove the four speaker mounting screws. by CHAPTER below. Remove the six screws securing the speaker grille; remove the speaker grille and set aside. bulb &o Power Supply — Adjustment CAUTION Adjust the power supply slowly to prevent over-voltage damage to the PCB. During adjustment, do not push the adjustment knob hard with the screworiver, because it is an easily damaged plastic part. The 5 volt power (supply) adjustment knob is located on the top of the power supply and can be turned with a small flat-blade screwdriver.
If the power LED indicators show that the voltage needs to be adjusted (see Table 3-2), use the following procedure. 3-3