AREA SAFETY 51 OPpERATOR’S MANUAL INTRODUCTION SUMMARY The following safety precautions apply to all game operators and service personnel. Specific warnings and cautions will be found in this manual whenever they placed in fuse type, voltage rating, and current rating. In addition, the fuse cover must be in place during game operation. apply. CAUTION WARNING Handle Disk Drive Unit With Care. Use special care Properly Ground the Game. Players may receive an electrical shock if this game is not properly grounded! To avoid electrical shock, do not plug in the game until it has been inspected and properly grounded. This game should only be plugged into a grounded threewire outlet.
If you have only a two-wire outlet, we recommend you hire a licensed electrician to install a three-wire grounded outlet. when installing the circuit boards and handling the hard disk drive. Take basic precautions to avoid excessive impact or electrostatic discharges. Attached to the hard disk drive is a shock indicator that detects severe impacts. Do not remove or tamper with this indicator. Thoroughly review the operator’s manual and videotape provided with this product. AC Power Connection. Before you plug in the game, be sure that the game’s power supply can accept the AC line voltage in your location. The line voltage requirements are listed in the first chapter of this manual.
connectors on each printed circuit board (PCB) are properly plugged in. The connectors are keyed to fit only one way. If they do not slip on easily, do not force them. If you reverse a connector, it may damage your game and void your warranty. Disconnect Power During Repairs. To avoid electrical shock, disconnect the game from the AC power before removing or repairing any part of the game. If you remove or repair the video display, be very careful to avoid electrical shock. High voltages continue to exist even after power is disconnected in the display circuitry and the cathode-ray tubes (CRTs). Do not touch the internal parts of the display with your hands or with metal objects!
Always discharge the high voltage from the CRTs before servicing them. Do this after you disconnect them from the power source. First, attach one end of a large, well-insulated, 18-gauge jumper wire to ground. Then momentarily touch the free end Ensure the Proper AC Line Frequency. Video games manufactured for operation on 60 Hz line power (used in the United States) must not be operated in countries of the grounded jumper wire to the CRT sliding the wire under utes and do this again. the anode anode by cap. Wait two min- Use Only Atari Parts. To maintain the safety of your Atari game, use only Atari parts when you repair it.
Using non-Atari parts or modifying the game circuitry may be dangerous, and could injure you and your players. Handle the CRTs With Care. If you drop a CRT and it breaks, it may implode! Shattered glass from the implosion can fly six feet or more. Use the Proper Fuses. To avoid electrical shock, use replacement fuses which are specified in the parts list for this game. Replacement fuses must match those re- Properly Attach All Connectors, Make sure that the with 50 Hz line power (used in Europe). If a 60 Hz machine operates on 50 Hz line power, the fluorescent line ballast transformer will overheat and cause a potential fire hazard.
Check the product identification label on your machine for the line frequency required. ABOUT NOTES, CAUTIONS, AND WARNINGS In Atari publications, notes, have the following meaning: cautions and warnings NOTE —- A highlighted piece of information. CAUTION — Equipment and/or parts can be damaged or destroyed if instructions are not followed. You will void the warranty on Atari printed-circuit boards, parts thereon, and video displays if equipment or parts are damaged or destroyed due to failure of following instructions. 0 WARNING A — Players and/or technicians can be killed or injured if instructions are not followed. Précautions de’Emploi Générales '\™ lil