Application Sample and Calibration Wizards Conveyor Belt Controls The following controls require that: l the belt is under active control by the Adept controller, l the conveyor supports the selected control (for example, to use Reverse/Forward, the conveyor must have a motor that supports operation in reverse direction), l the appropriate control signals have been defined in the Belt object editor. For details, see Belt on page 809. Vision Controls For details on the following items, see the ACE Sight User's Guide.
Application Sample and Calibration Wizards For application samples, belt calibrations, and sensor calibrations, there are special "interview" wizards that step you through these tasks. These wizards contain a "step" pane, on the left-hand side of the wizard screen, which shows the list of steps and the step you're currently on, as shown in the following figure. ACE User's Guide, 3.6.x 18316-000 Rev A Page 184 Item Description Taught Pos- ition Displays the taught (recorded) position. Item Description Fast/Slow Selects fast or slow speed. Click the Signal ( / ) icon to toggle the signal state. On/Off Starts and stops the conveyor belt. Click the Signal ( / ) icon to toggle the sig- nal state.
Reverse/Forward Selects forward or reverse direction. Click the Signal ( / ) icon to toggle the sig- nal state. Item Description Edit Opens the Vision Tools Properties window, which is used to edit various parameters of the vision tool. Live Displays a live image from the camera input. Picture Acquires a still image from the camera input. Stop Stops the currently-running vision tool or process. (This is only active in Live mode.)