Inspection results for the selected mode will be displayed. Some modes require just one vis- ion tool. Limits You set the minimum and maximum limits, and nominal value, to determine how the filter behaves. You can run the tool from this form. When the tool runs, it will show the current and average values for instances that pass the fil- ter. l Minimum and Maximum determine whether an instance passes or fails the filter. l Nominal is used in calculating the deviation result. It does not influence passing or failing. Average/Current Values The tool can be run once or repetitively, (by clicking Cycle), from within the fil- ter editor, to test the values set for the limits.
This lets you determine the appro- priate values for the limits. l Average is the average value obtained from the tool since Average was last cleared. l The box to the right of Average displays how many iterations of the tool were used to obtain the average. l Current Value displays the most recent result of the tool. You can click the buttons that follow to run the tool once, run continuously, stop a continuous run, or clear the Average value (so you can start another con- tinuous run). Run the tool once Run the tool continuously Stop the tool from running Reset the average value and iteration count When the tool runs, the current value will be compared against the filter limits.
ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 541