Inspection l If the current value is between the limits, the limit indicator boxes will be green. l If the current value is out of range, the indicator for the limit that was exceeded will change to red, and the other limit indicator will be blank. See the following figure. l If either limit is exceeded, the Nominal indicator will be red. Inspection Filter Editor, with Maximum Limit Exceeded Filters Sub-properties Configuration If you select Test The Value Of A Vision Result Variable as your Mode Of Oper- ation, you will be asked for a Vision Tool and a Result. The Vision Tool uses the same selection method as other Modes Of Operation, but the Result field has its own window.
The window will first display the available sub-properties that can be used for testing. ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 542