omron — ACE Sight Camera Calibration

ACE Sight Camera Calibration l Move the Robot to the Picture Position 1. Move the robot so the camera is over the target. The target must be in the camera's field of view. 2. Click Here. l Teach the Vision Tool See the preceding figures, Vision Model Before Teaching and Vision Model After Teach- ing . 1. Place the target near the center of the work area. 2. Click Run to take an image. 3. Adjust the model bounding box to fully enclose the model. Make it close to the perimeter of the model, as shown in the following figure. 4. Move the origin marker to the center of the model. l Drag the origin marker to the center of the model with the mouse or ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 683