ACE Sight Camera Calibration l Click Edit o Click Center to center the marker on the bounding box or o Click on the outline of the model, then click Center to center the marker on the found part The Edit window is shown in the following figure. Edit Window l Locate the Target 1. Adjust the bounding box to the work area. This must include the calibration tar- get. NOTE : The calibration target should be correctly adjusted from the cal- ibration procedure. 2. If no magenta origin marker is displayed, click Run. If necessary, move the target so it can be located, then click Run. ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 684