Process Components NOTE: When the mode is Latch, the latch information is taken from the Belt object linked to the Belt Properties. l Pallet Pallet is an optional parameter that specifies the parts are acquired from a pallet or placed into a pal- let. This optional parameter can be used in conjunction with a Belt, Static, or Vision configuration. It is important to note that when used with a Vision or Belt, the vision or belt is configured to locate the origin of the pallet, not the parts in the pallet. l Part Process The Process Manager is responsible for processing Parts input to the system and routing them to a Part Target. To do so, it maintains a Part Process list.
A Part Process identifies an Adept Robot that can pick a Part or collection of Parts and place it at a Part Target or collection of Part Targets. l If a Part or Part Target is a pallet, then the Part Process object allows for a Pallet Exclusion Configuration to be defined. The user can limit the pallet positions that can be accessed by the robot in this configuration. l A relative priority can be associated with a given part process. This priority is used by the Pro- cess Manager when allocating parts to robots. l The Part Process defines a gripper pick configuration and where the robot will place the parts. NOTE: The Part Process defines a possible processing scenario for handling a Part.
The Process Strategy is responsible for deciding which robots will process which parts. This is done using the list of Part Process objects as a guide to the valid combinations. The Process Manager examines the list of Part and Part Targets associated with the Part Processes defined by the user. It will generate a list of Calibration objects, which are displayed to the user, as follows: l Robot-to-Belt Calibration l Robot-to-Belt-Camera Calibration l Robot-to-Belt-Latch-Sensor Calibration l Robot-to-Fixed-Camera Calibration l Robot-to-Belt-Spacing-Reference Calibration Each calibration object relates the robot to another hardware element in the application.
ACE User's Guide, 3.6.x 18316-000 Rev A Page 802 Belt Mode Vision Properties Spacing Vision Required Not Used Latch Not Used Not Used Spacing Not Used Required