Editor Parameters The origin of the belt is defined as the farthest upstream point on the belt; the X-axis orientation defines the flow of the belt. Encoders Group The Encoders group is used to specify various controls for a conveyor belt, as follows: The controller properties table provides the following controls for the encoder selected in the Encoder list. If there is more than one controller associated with an encoder, each association will be displayed in a sep- arate row of the table. For this case, it is possible to have more than one entry in the table grid area.
ACE User's Guide, 3.6.x, 18316-000 Rev A Page 815 Item Description Width Enter the width (in millimeters) for the conveyor belt. Length Enter the length (in millimeters) for the conveyor belt. Show in Visu- alization If selected, the conveyor belt will be shown in the 3D Visualization window. For details, see 3D Visualization on page 176. Item Description Add/Delete But- tons Click Add to add a new encoder to the Encoder list. To remove an existing encoder from the list, select the encoder name and then click Delete. Name Enter a descriptive name for the encoder. A default encoder name is assigned when the new encoder is added to the Encoder list.
Associate/Remove Buttons Click Associate to specify the controller to associate with the selected encoder. The Select a Controller dialog opens, which allows you to select an existing con- troller to associate with the encoder. To remove an association, in the table area, click the row-selector ( ) icon for the controller/encoder you wish to change, and then click Remove. The following items are added when emulation mode is enabled. Latch Period in Emulation Mode Specifies the latch period, in millimeters, that will be used when emulation mode is enabled. Item Description Controller column Displays the name of the controller assigned to the selected encoder.
Encoder Chan- nel Specifies the channel number to use for the selected encoder. Double-click the cell to edit the encoder channel number. This number is zero-based. Latch Enabled Select this check box to enable latching for the selected encoder.