omron — Editor Parameters

Editor Parameters ACE User's Guide, 3.6.x 18316-000 Rev A Page 816 Item Description When emulation mode is enabled and the latch is not configured, you are promp- ted to have the latches automatically configured. Configure Latches Prompt Click Yes to configure the latches and open the Configure Encoder Latches tool. For more details on configuring latches, see Encoder Latches on page 198. For more details on Emulation Mode, see Emulation Mode on page 1089. NOTE: If there is a configuration error and the alert icon ( ) is displayed, you can double-click the icon to show the prompt in the previous figure and then click Yes to open the Configure Encoder Latches tool.

Input Number Specifies the digital I/O latched signal input number for the selected encoder. Double-click the cell to edit the latch signal input number. You can enter more than one latch signal number, each one must be separated by a comma (1001, 1002, etc.). The available latch signals are defined in the Robots section of the V+ Configuration file. For details, see V+ System Con- figuration Editor on page 221. You can then configure the robot-to-belt cal- ibrations to use a specific latch signal. By doing so, you will have multiple robot- to-camera calibrations sharing the same relative robot-to-belt calibration.

For more details, see Defining Multiple Latch Signals for a Belt Encoder on page 822. When emulation mode is enabled, the latch input signal(s) for each encoder will be emulated. For more details on Emulation Mode, see Emulation Mode on page 1089. Latch Distance (mm) Specifies the minimum latch distance for the selected encoder. Double-click the cell to specify the desired value. Scale (mm/count) Specifies the millimeters of belt travel per encoder count for the selected encoder. Double-click the cell to specify the desired value. This information will be automatically generated when you calibrate the robot to the belt encoder. For details, see Belt Calibrations on page 848.