omron — Configuration Items

Configuration Items Direct-edit, Predefined-list, and check box Items 3. After you have completed editing the values on the grid, you can close the editor by clicking the close icon ( ) in the upper-right corner of the grid editor window. To edit multiple items in the grid editor 1. Select the cells you wish to edit: l Select non-adjacent cells: Press the Ctrl key while clicking the cells l Select a series: Click the first cell and then press the Shift key while selecting the last cell; click in the first cell and drag to select nearby cells l Select a series: Click in the first cell and drag to select nearby cells NOTE: The selected cells must be the same type. 2.

Type the desired value for the selected cells. All cells are updated to show the new value. 3. After you have completed editing the values on the grid, you can close the editor by clicking the close icon ( ) in the upper-right corner of the grid editor window. Offset Controls The Offset Locations section contains an additional editing control, as shown in the following figure: Offset Controls The control allow you to increment the selected offset coordinates, as follows: 1. Use the mm field or slide control to enter the desired increment value 2. Use the Up or Down arrows ( ) to apply the increment value to the selected cells in the Offset ACE User's Guide, 3.6.x 18316-000 Rev A Page 868