Control Sources Locations grid. The Up arrow increases the value by the increment amount; the Down arrow decreases the value by the increment amount. Control Sources This section describes the Control Sources editor in the Process Manager. For details, see Process Manager on page 843. The Control Sources editor defines the properties for part and target hardware sources, as required by the selected workcell configuration.
For example, if you have a part that is being fed on a conveyor belt, you can use the Control Sources button to access the Source Configurations editor, which allows you to con- figure (select) the controller for that belt and, optionally, a custom V+ belt-control program, as shown in the next section. Editing a Control Source As you add items to the workspace, any item that can have a control source (for example, a conveyor belt) is automatically added to the Source Configurations editor list. To edit a control source: 1. On the Process Manager menu, click the Control Sources menu item. 2. The Control Sources editor opens. 3. Select an item for editing.
For example, in the following figure, the Belt Source is selected, which dis- plays the corresponding control parameters. 4. Edit the parameters for the selected item. 5. Click OK to close the editor. Belt Control Sources NOTE: When emulation mode is enabled, this item contains additional features. For more details on Emulation Mode, see Emulation Mode on page 1089. ACE User's Guide, 3.6.x, 18316-000 Rev A Page 869