omron — Code and Description List

Code and Description List ACE User's Guide, 3.6.x, 18316-000 Rev A Page 933 Code Description C R G CV BE L F P PT Pa Cs O -20148 Custom process strategy selection program is not defined. x x -20147 The camera calibration references a latch that does not exist in '{1}' x x -20146 The latch calibration cannot have multiple latches x -20145 The Custom Process Strategy Allocation Algorithm Has Failed To Execute. x x -20144 Custom Robot Process Strategy Algorithm Not Defined. x x x -20143 The controller associated with belt '{1}' does not appear in the process list. x x x -20142 Refinement station not defined in the process. x x -20141 The process has not been taught.

x -20140 There are no latches referenced by '{0}' for the belt '{1}'. x x -20139 Custom robot wait program is not defined. x x -20138 Custom robot program is not defined. x x -20137 Custom stop program is not defined. x -20136 Custom error program is not defined. x -20135 The expected latch signal associated with cam- era '{0}' was triggered multiple times on con- troller '{1}'. x x x -20134 The expected latch signal associated with cam- era '{0}' was not detected on controller '{1}'. x x x -20133 A configuration item name is too long: {2}. x -20132 The calibration key is too long to write to the controller.

x -20131 The robot end-effector key name associated with '{1}' is too long to write to the controller. x x -20130 '{0}' is too long to write to the controller. x -20129 '{0}' is defined as a belt spacing configuration. x x x