14 Maintenance Figure 8. SAE Oil Viscosity Classes To insure the engine is protected and the oil stays clean until the next oil change, use only oils of API classification CI4. The six-cylinder EGR engines have an oil centrifuge and an oil filter. Non-EGR engines have only an oil filter. NOTICE: Both the primary lube oil filter (front of engine) and the oil centriguge cartridge (side of engine) must be replaced at each oil drain interval. Change the oil filter as follows: 1. Chock the tires, place the transmission in neutral, and set the parking brake. NOTE: Change the engine oil only when the engine is at an operating temperature of approximately 82°C (180°F). 2.
Using a 36-mm socket, unscrew the oil filter cap. Figure 9. Oil Filter Cap 3. Place a suitable receptacle beneath the oil drain plug on the underside of the oil pan. Carefully unscrew the oil drain plug on the oil pan and allow the oil to drain out. Discard the O-ring on the oil drain plug. 38 All information subject to change without notice. Copyright © 2019 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0207