MAN — 15.4 Engine Out of Fuel – How to Restart

EuroV MBE 900 Operators Manual 15.3.3 Biodiesel 1 General recommendations and guidelines Detroit™ supports biodiesel as a renewable fuel. Biodiesel fuels are mono alkali esters of long chain fatty acids commonly referred to as Fatty Acid Methyl Esters (FAME) and are derived from renewable resources through a chemical process called transesterification. Detroit™ approves the use of biodiesel fuel blends as follows: DD Family of Engines - Biodiesel blends up to 5% are allowed MBE900/4000 Engines - Biodiesel blends up to 5% are allowed S60 Engines - Biodiesel blends up to 20% are allowed* *Engines built prior to MY 2004 may contain materials that are not compatible with biodiesel blends.

Biodiesel blends above 5% are not recommended 2 . For most recent information go to DTNAConnect ( https://dtnacontent-dtna.prd.freightliner.com/content/dam/public/dtna- servicelit/ddc/pdfs/Lube_Oil_Coolant/Detroit_Bio_Fuel_Position_Statement.pdf ). 15.3.4 Prohibited Additives The following fuel additives are not allowed and MUST NOT be mixed with diesel fuel: Used Lubricating Oil Do not use fuel blended with used lubricating oil. Detroit™ specifically prohibits the use of used lubricating oil in diesel fuel. Used lubricating oil contains combustion acids and particulate materials which can severely erode fuel injector components, resulting in loss of power and increased exhaust emissions.

In addition, the use of drained lubricating oil will increase maintenance requirements due to filter plugging and combustion deposits. WARNING: FIRE To avoid increased risk of a fuel fire, do not mix gasoline and diesel fuel. NOTICE: Detroit™ will not be responsible for any detrimental effects resulting from adding drained lubricating oil or gasoline to the diesel fuel. Gasoline The addition of gasoline to diesel fuel will create a serious fire hazard. The presence of gasoline in diesel fuel will reduce fuel cetane number and increase combustion temperatures. Drain and clean tanks which contain a mixture of gasoline and diesel fuel as soon as possible.

Fuel Additives with Sulfur or Sulfated Ash Do not use non-approved fuel additives containing sulfur or sulfated ash. 15.4 Engine Out of Fuel – How to Restart When an engine has run out of fuel, there is a definite procedure to follow when restarting it. NOTICE: Never use the starting motor and fuel pump to prime the fuel filters. Prolonged use of the starting motor and fuel pump to prime the fuel system can result in damage to the starter, fuel pump, and injectors. Use the following procedure to prime the fuel system: NOTE: If a vehicle is on uneven ground, more fuel may be required. 1. Fill the fuel tank with the recommended grade of fuel.

If only partial filling is possible, add a minimum of 10% of the total tank volume of fuel to the tank. For example, a 150-gallon tank would require a minimum of 15 gallons of fuel. 2. Connect a Detroit-approved priming tool or operate the engine-mounted hand primer for three minutes or 250 strokes. 3. Turn on the ignition switch. 4. Wait for the engine system indicator lights on the instrument panel to go out. All information subject to change without notice. 49 DDC-SVC-MAN-0207 Copyright © 2019 DETROIT DIESEL CORPORATION