MAN Nutzfahrzeuge Aktiengesellschaft — EDC control box for idle speed adjustment

Test EDC control box for idle speed adjustment Flash code: 1x long, 13x short Fault indication: Fault is not indicated by the EDC indicator lamp Fault path: Operating unit defective Voltage values incorrect or implausible Effect of fault: The idle position can no longer be activated. If the fault was only temporary (e.g. operating unit activated several times) the system will be ready for operation after switching the “ignition” off an on again. Function: The operating unit is resistor-coded, i.e. the control unit recognizes each switching state according to the voltage level supplied. Faults are detected when incorrect values are output over a certain period of time; e.g.

electrical fault or multiple operation (incorrect operation) of the operating unit. Possible cause: Line break, short-circuit, operating unit defective, incorrect operation Test precondition: EDC control unit connected socket box connected ignition switched on 43 Test Measurement Corrective measures Control box Measure voltage at the socket box across pin 44 and pin 13 Switch through all settings of the operat- ing unit and determine relevant voltage value Setpoints: SET+: 0.65–0.97 V SET–: 2.31–2.75 V MEMORY: 1.41–1.81 V OFF: 3.72–4.33 V Not activated:

3.15–3.55 V – Check lines – Check plug connections – Replace the control box – If no fault found, replace control unit as a check (disconnect the control unit only when the cur- rent is switched off)