3.2 Explanation of components Operation 19. Room lamp switch a The switch (19) is used to turn the room lamp ON and OFF. Position (a): OFF b Position (b): Lights up when the cab door opens Position (c): Lights up c REMARK The room lamp lights up even when the main switch is OFF, so when leaving the operator's compartment, turn the switch to position (a) (OFF) or (b). When operating with the cab door fully open, set the switch to position (a) (OFF). GK043134 20. Rear heated wire glass switch W hen this switch (20) is pressed, electric current flows through the heated wire glass at the rear and the mist is removed from the glass. a Position (a): ON (removes mist from glass) Position (b):
OFF b GK038032 21. E.C.S.S. switch (*) (*) E.C.S.S.: Electrically Controlled Suspension System ! If the machine is traveling or the work equipment is raised, the moment the E.C.S.S. switch is turned ON, the work equipment will move. ! If the E.C.S.S. system is switched on, the work equipment may move. ! Never turn the E.C.S.S. switch ON during inspection or maintenance. The work equipment will move and this will create a dangerous situation. NOTE ! Always stop the machine and lower the work equipment to the ground before operating the E.C.S.S. switch. ! When carrying out inspection and maintenance, first lower the work equipment to the ground, then turn the E.C.S.S.
switch OFF before starting the inspection and maintenance operation. ! When carrying out leveling work, turn the E.C.S.S. switch OFF. 3-52 WA380-6H – VEAM440100 WARNING WARNING