Operation 3.3 Operation Load and carry operations ! When carrying a load, lower the bucket to lower the center of gravity when traveling. ! When the machine is traveling or the work equipment is raised, the moment that the E.C.S.S. switch is turned ON, the work equipment will move. ! If operations are carried out with the E.C.S.S.switch left at the ON position, the moment that the travel damper is actu- ated, the work equipment will move. GK032211 The load and carry method for wheel loaders consists of a cycle of scooping -> hauling -> loading (into a hopper, truck, etc). Always keep the travel path properly maintained.
When using the load and carry method, see "Precautions for using load and carry method (3-139)". Loading operations Select the method of operation which will give the minimum amount of turning and travel in order to provide the most efficient method for the jobsite. ! Always keep the jobsite flat, and do not operate the steering wheel suddenly or apply the brakes suddenly when the lift arm is raised with a loaded bucket. This is dangerous. ! Never thrust the bucket in when traveling at high speed (when loading soil or crushed rock). This is dangerous. ! When the machine is traveling or the work equipment is raised, the moment that the E.C.S.S.
switch is turned ON, the work equipment will move. ! If operations are carried out with the E.C.S.S. switch left at the ON position, the moment that the travel damper is actu- ated, the work equipment will move. ! If the tires slip, the tire life will be reduced, so do not allow the tires to slip during operation. NOTE ! Avoid excessive bucket shaking. WA380-6H – VEAM440100 3-127 WARNING WARNING WARNING WARNING