Komatsu — 3.3.11 Adjusting work equipment posture

Operation 3.3 Operation Precautions regarding brake function When traveling long distances continuously downhill, the fre- quency of using the brake may increase. As a result, depending on the weight of the machine and the grade of the slope, the machine's braking capacity may be exceeded and the brakes may overheat. The table below shows a guideline of the values for this machine. If the braking capacity limit is exceeded, a forced cooling system for the brakes is needed, so please consult your KOMATSU dis- tributor. 3.3.11 Adjusting work equipment posture ! Stop the machine on flat ground and put blocks in front and behind the wheels. !

Set the parking brake switch to the ON position (A) to apply the parking brake. ! Secure the front and rear frames with the safety bar. ! Always attach the warning tag to the work equipment control lever. ! Do not go under the work equipment when the arm is raised. The boom kickout makes it possible to set the bucket so that it automatically stops at the desired lifting height (lift arm higher than horizontal) and the bucket positioner makes it possible to set the bucket so that it automatically stops at the desired dig- ging angle. The setting can be adjusted to match the working conditions.

Free Lock GK038011 WA380-6H – VEAM440100 3-131 Machine weight (t) Slope grade (%) Braking capacity limit Average travel speed limit (km/h) Downhill distance limit (continuous) (km) 17.3 - 19.5 (unloaded) 10 40 (24.9) 1.9 20 38 (23.6) 0.6 22.5 - 24.5 (loaded) 10 38 (23.6) 1.5 20 32 (19.9) 0.5 WARNING WARNING OFF ON GK03 8008