Komatsu — Adjusting bucket positioner

3.3 Operation Operation Adjusting boom kickout 1. Raise the bucket to the desired height, set the lift arm control lever at HOLD, then set the safety lever to the LOCK posi- tion and stop the engine. 4 3 2. Loosen two bolts (1), and adjust plate (2) so that the bottom edge is in line with the center of the sensing surface of prox- imity switch (3). Then tighten the bolts to hold the plate in position. 1 3. Loosen two nuts (4) to make a clearance of 3 to 5 mm between plate (2) and the sensing surface of proximity switch (3). Then tighten the nuts to hold in position. Tightening torque: 17.2 ± 2.5 Nm 2 4. After adjusting, start the engine and operate the lift arm con- trol lever.

Check that the lever is automatically returned to HOLD when the bucket reaches the desired height. GK038088 Adjusting bucket positioner 1. Lower the bucket to the ground, set to the desired digging angle, return the bucket control lever at HOLD, then set the safety lever to the LOCK position and stop the engine. 1 2. Loosen 2 bolts (1), adjust the position of mounting bracket (4) of the proximity switch so that the rear tip of bar (2) is in line with the center of the sensing surface of proximity switch (3), then tighten bolts to hold the bracket in position. 5 3.

Loosen 2 bolts (5), adjust so that the clearance between bar (2) and support (6) is 0.5 to 2 mm, then tighten bolts (5) to hold in position. 2 6 7 3 4 GK038089 4. Loosen 2 nuts (7), adjust so that the clearance between bar (2) and the sensing surface of proximity switch (3) is 3 to 5 mm, then tighten the nuts to hold in position. Tightening torque: 17.2 ± 2.5 Nm 5. After adjusting, start the engine and raise the lift arm. Oper- ate the bucket control lever to the DUMP position, then oper- ate it to the TILT BACK position and check that the lever is automatically returned to the HOLD position when the bucket reaches the desired digging angle. 3-132 WA380-6H – VEAM440100