4.9 Service procedure When required Maintenance 9. Replace the corrosion resistor cartridge (if equipped), then open 2 valves (1). For details of the procedure for replacing the corrosion resis- tor, see "Replace corrosion resistor cartridge (4-75)". 10. Add coolant mixed with antifreeze until it overflows from the water filler. Decide the proportions of antifreeze and water according to the table for the mixing rate of water and antifreeze. 11. To remove the air in the cooling system, run the engine for 5 minutes at low idling, and for another 5 minutes at high adling. (When doing this, leave the radiator cap off.) 12.
Drain the coolant from sub-tank (4), clean the inside of the sub-tank, then add water until the coolant level is between the FULL and LOW marks. 13. Stop the engine, wait for approx. 3 minutes, then add coolant until the coolant level is near the coolant filler port, and tighten the cap. Check the coolant level and add coolant if necessary.. GK038073 4 GK032247 4-38 WA380-6H – VEAM440100