4.9 Service procedure Every 250 hours service Maintenance Adjusting 1. Loosen bolt (1), then loosen the locknut of bolt (2), tighten bolt (2), and move compressor (3) to adjust. 1 2. Tighten bolt (1) and the locknut of bolt (2) to hold the com- pressor (3) in position. NOTE ! Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V- belt is not touching the bottom of the V-groove. 3 2 ! In case any of the following occurs, ask the KOMATSU dis- tributor in your territory to replace the belts with new ones. The fan belt has elongated, leaving little allowance for adjustment. A cut or crack is found on the belt.
Slipping or creaking sound is heard coming from the belt. GK038111 ! When the new V-belt is set, readjust it after one hour of oper- ation. Check for loose wheel hub bolts, tighten If wheel hub nuts (1) are loose, tire wear will be increased and may cause accidents. 1. Check for loose nuts, and tighten if necessary. When checking for loose nuts, always turn the nuts in the direction of tightening to check. Tightening torque: 825 to 1030 Nm 2. If any stud bolt is broken, replace all the stud bolts for that wheel. 4-62 WA380-6H – VEAM440100 1 GK03227