Safety 2.4 Precautions for maintenance Precautions with high-pressure oil The hydraulic system is always under internal pressure. In addi- tion, the fuel piping is also under internal pressure when the engine is running and immediately after the engine is stopped. When carrying out inspection or replacement of the piping or hoses, check that the internal pressure in the circuit has been released. If this is not done, it may lead to serious personal injury. Always do as follows. ! When carrying out inspection and maintenance of the pres- sure, release the pressure before starting. For details, see "Maintenance with engine running (2-34)".
Do not carry out inspection or replacement work with the circuit under pres- sure. ! If there is any leakage from the piping or hoses, the sur- rounding area will be wet, so check for cracks in the piping and hoses and for swelling in the hoses. When carry out inspection, wear safety glasses and leather gloves. GK032082 ! There is a hazard that high-pressure oil leaking from small holes may penetrate your skin or cause blindness if it con- tacts your eyes directly. If you are hit by a jet of high-pres- sure oil and suffer injury to your skin or eyes, wash the place with clean water, and consult a doctor immediately for medi- cal attention. ! The pressure in the E.C.S.S.
circuit is stored by an accumu- lator. Do not remove the E.C.S.S. piping or components. If it is necessary to remove them, please ask your KOMATSU distributor to carry out the removal operation. Precautions for high-pressure fuel High pressure is generated inside the engine fuel piping when the engine is running. When carrying out inspection or mainte- nance of the fuel piping system, wait for at least 30 seconds after stopping the engine to let the internal pressure go down before starting inspection or maintenance. WA380-6H – VEAM440100 2-39