John Deere 230LCR, 230LCRD — CHAPTER 5

TM 5-3805-280-10 Operating the Engine USING THE ARCTIC STARTER The arctic starter is a fuel fired coolant heater located between the engine and the rear counterweight. The exhaust pipe comes out the bottom of the heater box and can be accessed by removing the lower bottom cover at the rear of the vehicle. CAUTION: Prevent possibility of fire by keeping the area around the arctic starter exhaust pipe clean and free of debris. The exhaust pipe outlet must be directed away from electrical wiring, hydraulic hoses, fuel lines, and cold weather starting aid lines. Prevent asphyxiation. Exhaust fumes from operating the arctic starter can cause sickness or death.

Never operate in an enclosed area or building unless there is adequate ventilation to expel the exhaust fumes. The arctic starter must be used when the engine has been off for at least eight hours at ambient temperatures below -32 ° C (-25 ° F) and is recommended at temperatures below -23 ° C (-10 ° F). Ignite the arctic starter and allow to run for 45 minutes. Then shut the arctic starter OFF and start the engine. (See Starting The Engine in this manual.) NOTE: The arctic starter may not ignite at ambient temperatures below -40 ° C (-40 ° F). The arctic starter does not preheat any oils. All oils must be of the proper viscosity depending upon the ambient air temperature.

(See Fuels And Lubricants in this manual.) CED,OUOE020,11 –19–26FEB99–1/1 5-7