John Deere 230LCR, 230LCRD — CHAPTER 5

TM 5-3805-280-10 Operating the Engine COLD WEATHER WARM-UP CAUTION: Prevent possible injury from unexpected machine movement. If hydraulic oil is cold, hydraulic functions move slowly. DO NOT attempt normal machine operation until hydraulic functions move at close-to-normal cycle times. 5. Swing upperstructure so boom is perpendicular to tracks. CAUTION: Prevent possible injury from machine sliding backwards. Keep angle between boom and arm 90—110 ° . In extremely cold conditions, an extended warm-up period will be necessary. Under such conditions, the radiator and oil cooler should be covered to maintain correct operating temperature. 6.

Keeping the angle between boom and arm 110 ° , fully actuate bucket close function (cylinder extend) and lower bucket to raise track off ground. Avoid sudden operation of all functions until the engine and hydraulic oil are thoroughly warm. IMPORTANT: Holding function actuated for more than 10 seconds can cause damage from hot spots in the control valve. 1. Run engine at 1/2 speed for 5 minutes. Do not run 7. While rotating raised track in forward direction, at fast or slow idle. actuate bucket curl function (cylinder extend) for 10 seconds and release for 5 seconds for a period of 2-1/2 minutes. CAUTION: Prevent possible injury from unexpected machine movement.

Clear the area of all persons before running your machine through the warm-up procedure. If machine is inside a building, warm the propel circuit first and move the machine to a clear area outside. Cold oil will cause machine functions to respond slowly. 8. Repeat procedure with track rotating in reverse direction. 9. Lower machine to ground. 10. Repeat steps on opposite track. 11. Operate all hydraulic functions to distribute warm 2. Exercise propel and swing functions slowly, initially moving only short distances. oil in all cylinders, motors, and lines. 3. Operate boom, arm, and bucket functions by 12.

If hydraulic functions still move slowly, repeat moving cylinders a short distance each direction for the first time. steps 6 and 7. 4. Continue cycling cylinders by increasing the travel each cycle until full stroke is obtained. TX,25,DH5504 –19–21JUN95–1/1 5-10