TM 5-3805-280-10 Operating the Machine AUTO-IDLE SWITCH The auto-idle circuit automatically reduces engine speed after 4 seconds when control levers are placed in neutral position. Press switch (A) to turn circuit ON. CAUTION: Turn auto-idle switch OFF when automatic acceleration of engine speed is not desired, and when stopping engine. Always check auto-idle switch before operating any control levers. When ON, the engine speed lowers to auto-idle speed (regardless of the position of the engine speed control lever) approximately 4 seconds after the control levers are returned to neutral. By operating the control levers, the engine speed increases to the engine rpm dial setting.
Starting engine when auto-idle is ON: 1. When key switch is turned ON, buzzer will sound T107692 –UN–27FEB97 briefly. 2. The engine will run at the engine rpm dial setting for 4 seconds after turning the key switch ON. The auto-idle system will then slow the engine to auto-idle engine speed. 3. Engine speed increases to engine rpm dial setting when any control lever is operated. 4. Four seconds after control levers are returned to neutral, the engine speed is reduced automatically to auto-idle level. Engine will run at auto-idle speed if engine is started more than 4 seconds after turning key switch ON.
When the auto-idle switch is turned OFF, the engine speed is controlled by the engine rpm dial. Indicator (B) will light when auto-idle is ON. Turn auto-idle switch OFF and set engine rpm dial to improve machine control in difficult work areas, loading, and unloading. TX,35,DH5406 –19–27FEB97–1/1 7-7