TM 5-3805-280-10 Operating the Machine USING QUICK-DISCONNECT HITCH 1. The cylinder in the Quick-Disconnect Hitch is powered by hydraulic oil from the excavator bucket cylinder which is diverted to the Quick-Disconnect by an electric solenoid valve. The switch is located on the left side rear cab glass. T121059 –UN–28OCT99 NOTE: The solenoid coil is energized only in the unlatch position. 2. To attach the Quick-Disconnect Hitch to an attachment manually lift and rotate the safety lock pin lever on the top rear of the Quick-Disconnect Hitch. Fully extend the bucket cylinder and set the Quick-Disconnect Hitch switch (A) to the unlatch position.
Extend the bucket cylinder again to place the oil over relief (except for rock drill attachment). This will activate the cylinder to the open position. A—Quick-Disconnect Hitch Switch CED,OUOE042,65 –19–09DEC99–1/8 3. Operate the excavator to position the Quick-Disconnect Hitch in the vertical position (B). The attachment must be level and resting on the ground. T120310 –UN–25MAR99 Continued on next page CED,OUOE042,65 –19–09DEC99–2/8 7-16