TM 5-3805-280-10 Operating the Machine OPERATING IN WATER AND MUD Be careful not to operate the machine in water or mud above the upper deck surface of the undercarriage, causing the swing bearing and rotary manifold to be submerged. T6274AR –UN–20APR89 If the swing bearing and rotary manifold are submerged, remove cover from underneath center of machine. Remove drain plug (A) to drain water and mud. Clean swing gear area. Install plug and cover. Lubricate swing gear and swing bearing. (See Maintenance—Every 500 Hours chapter.) TX,35,FF2007 –19–06JUL94–1/1 CLEAN TRACK FRAME AREA 1. Swing upperstructure 90 ° . CAUTION: Prevent possible injury from machine sliding backwards.
Keep angle between boom and arm 90-110 ° . T6879AT –UN–06DEC88 2. Lower bucket (round side down) to raise track off ground, keeping angle (A) between boom and arm 90-110 ° . 3. Run track back and forth to remove mud and dirt. 4. Turn engine off. CAUTION: Prevent possible injury from unexpected machine movement. Place blocks under machine frame to support machine while cleaning track frame area when track is stationary. 5. Place blocks under machine frame if further cleaning of track frame area is performed while track is stationary. Clean track often during cold weather to prevent damage to track components. TX,35,DH5513 –19–06AUG91–1/1 7-29