TM 5-3805-280-10 Speed and Pressure Regulation Adjusting Instructions 36518066 Normally, regulation requires no adjusting, but if proper adjustment is lost, proceed as follows: adjustment screw clockwise until throttle air (C) moves against full speed governor stop (D). Note: Refer to general data for machine rated speeds and pressure. 4. Insure that pressure is maintained at rated pressure, then turn regulator adjustment screw counterclockwise until throttle arm (C) just begins to move. Before Starting Unit: 1. Atop separator tank cover at pressure valve, loosen locknut counterclockwise. Turn adjustment screw and locknut counterclockwise until no tension is felt at the screw.
turn screw clockwise one full revolution. Note: Turning regulator adjustment screw clockwise will raise pressure at full speed. 5. Close service valve (engine will slow to idle speed). Loosen jam nut (E) on rod (A). Rotate rod (A) to adjust speed to obtain idle rpm. After Starting Unit: 2. Allow unit to warm up. Then at control panel, push “Service Air” Button, if equipped. 6. If necessary, repeat steps 3 and 4. 7. At pressure regulator, tighten lock nut. 8. Limit full load engine speed by loosening jam nut (F) and (G) and rotating rod (H). When proper speed is reached, tighten jam nuts. 3.
Open and adjust service valve (on outside of the unit) to obtain the rated operating pressure on the discharge pressure gauge. 9. To obtain maximum CFM at any pressure between 80 PSI (550kPa) and the rated operating pressure, turn adjustment screw of pressure regulator to obtain desired discharge pressure at full load engine speed. Always lock pressure setting of adjusting screw. Note: If the rated operating pressure cannot be maintained with engine at full load speed and rod (A) of air cylinder (B) fully retracted, turn regulator 7-33