TM 5-3805-280-10 Operating the Machine 4. Operate excavator to position hitch in vertical position and engage front hooks of rock drill adapter (A). 5. Rotate hitch downward to seat hitch and engage wedge into rock drill adapter (B). CAUTION: Do not raise the rock drill without acceptable wedge engagement. The rock drill can fall causing possible injury to people in the vicinity of rock drill. 6. Set quick-disconnect switch in cab to latch position. Rotate hitch downward a small amount to engage wedge bar. 7. Check for wedge engagement and manually engage hitch safety lock pin. NOTE:
See Using Quick-Coupler Type Attachments in this chapter for general operation tips and information on keeping the hydraulic system clean when connecting attachments. T126622 –UN–17DEC99 8. Remove cap from quick-disconnect fitting of high pressure hose on left side of excavator arm and plug from quick-disconnect fitting of low pressure hose on right side of excavator. Continued on next page CED,OUOESLH,6 –19–09DEC99–2/3 7-39