John Deere 230LCR, 230LCRD — CHAPTER 7

TM 5-3805-280-10 Operating the Machine ROCK DRILL ATTACHMENT (MODEL 230LCRD) Rock drill operation subjects the machine’s hydraulic system to possible contamination and accelerated deterioration. The hydraulic return filter and hydraulic oil must be replaced more often to prevent damage to hydraulic pumps and other hydraulic components. Change the hydraulic return filter and oil at the intervals recommended below based on the amount of machine operating time the attachment is used.

Percentage of Operating Time Hydraulic Return Filter Hydraulic Oil Change Rock Drill Used Change Interval (Hours) Interval (Hours) 100 100 600 60 150 800 40 200 1000 20 300 1300 TX,35,FF2664 –19–13MAY93–1/1 INSTALL ROCK DRILL 1. Ensure that rock drill is level and legs are resting on ground. NOTE: See Using Quick-Disconnect Hitch in this chapter for additional information when performing steps 2 through 7. 2. Manually place hitch safety lock pin in unlocked position. 3. Fully extend bucket cylinder and set quick-disconnect switch in cab to unlatch position. Continued on next page CED,OUOESLH,6 –19–09DEC99–1/3 7-38