John Deere 230LCR, 230LCRD — CHAPTER 7

TM 5-3805-280-10 Remote control operator’s panel OPERATING THE ROCK DRILL ATTACHMENT - REMOTE CONTROL OPERATOR’S PANEL A ) Guide swing control Feed control B ) Feed control This is a four–way lever with a push button on top. C ) Drifter control D ) Drilling hourmeter E ) Hydraulic centralizer control F ) Air flushing switch G ) Dust hood control H ) Thread loosening button (percussion) I ) HP / Dust collector selector B1 ) Pull the lever to operate the feed forward. The lever is locked in position. This is the normal posi- tion when drilling. J ) Emergency stop button K ) Rod changer control Guide swing B2 ) Push the lever to operate reverse feed. The lever must be held in position.

B3 ) Swing the lever in this direction to operate fast feed forward. The lever must be held in position. This control allows operation of the CPA swing. Swing the lever to the left to move the CPA foot piece to the left. B4 ) Swing the lever in this direction to operate fast reverse feed. The lever must be held in position. Swing the lever to the right to move the CPA foot piece to the right. B5 ) Pressing this button when the lever is pulled in B1 position operates the reduced feed for collaring. 7-43