John Deere 230LCR, 230LCRD — CHAPTER 7

TM 5-3805-280-10 Remote control operator’s panel Drifter control Air flushing This is a four–way lever. Pull the lever to operate air flushing. Dust hood control Pull the lever to slide the dust hood down. Push the lever to slide the dust hood up. Thread loosening button C1 ) Pull the lever to operate normal rotation only. C2 ) Push the lever to operate reverse rotation only. Note : these two functions are never used for thread coupling or uncoupling. C3 ) Swing the lever in this direction to drill with automatic control. Depress this button to operate drifter percussion only.

By successive impulses to the drifter control in C2 direction operate reverse rotation to break loose the threaded joints. This is the normal lever position when drilling. The lever is locked in position. C4 ) Swing the lever in this position to drill on manual. HP / Dust collector switch This is a 3 positions switch. In this specific position, the drilling automatics are inoperative. This lever position is exceptionally used to get full reverse percussion (if the drifter is so equipped), or to force the drilling when encountering faults by over– riding the anti–jamming. in such an occasion, rod jamming is risky.

Carefully reduce the feed speed by switching the feed control in collaring position. Drifter hourmeter J0) Down, HP flow is diverted to tank. The drifter hourmeter indicates the total operating of the drifter. J1) Middle, HP pressure built up to allow move- ments or auxiliaries. J2) Up, the dust collector is activated. It should be used to determine service mainte- nance. Emergency stop button Hydraulic centralizer control Press the button to switch down the engine in case of emergency only. Pull the lever to open the centralizer. Push the lever to close the centralizer. The emergency stops selector must be placed on CPA position (refer to safety). 7-44