John Deere 230LCR, 230LCRD — CHAPTER 7

TM 5-3805-280-10 Rod changer ROD CHANGER The rod changer is a semi–automatic device which allows: When an automatic mode is selected, the different movements of the rod clamps arms and those of the carousel are controlled automatically. This makes the different operations easiest and reduces the cycle time. the storage of 6 x 12’ extension rods in a carousel. the handling of the rod to and from the drill guide. Functions automatic operations for rod coupling and uncoupling. The synchronized drifter rotation and dis- placement are operated by a single lever.

When male/male extension rods are used, the upper rod clamp prevents hazardous sleeve loosen- ing which might occur during drifter shank uncou- pling. Thread lubrication is also controlled from the operator’s station. CONTROL PANEL Depressed the indicated pushed button to operate : M1 Rod clamps closing (upper and lower). M2 Carousel rotation (manual mode only). K) Rod changer control lever M3 Rod / drifter shank threads lubrication. M4 Rod clamps opening (upper and lower). The safety trigger located on the back of the lever must be depressed to allow any operation. M5 Carousel rotation (manual mode only).

L) Indicator light M1 + M4 Lower rod clamp closing, upper rod clamp opening (manual mode only). Move the rod changer control lever in the indicated direction to operate : This indicator is alight when the carousel is well positioned for adding or removing a rod. K1) Rod clamp arms swing towards the guide. S) Mode selector : K2) Rod coupling. S0) Manual mode. K3) Rod clamp arms swing into the carousel. S1) Automatic mode for rod adding. K4) Rod uncoupling. S2) Automatic mode for rod removing. 7-45