John Deere 230LCR, 230LCRD — CHAPTER 7

TM 5-3805-280-10 Rod changer LOADING THE CAROUSEL (MANUAL MODE S0) Loading the carousel with rods necessitates the presence of 1 or 2 assistants depending on the rods weight. 11) Perform steps 4 through 10 until the carou- sel is loaded with 4 extension rods (do not perform steps 9 and 10 after loading the last extension rod). Make sure that any hand signal will be perfect- ly understood. 12) Make sure the centralizer is open (switch E). The CPA should be lowered in its rest position to load the rod. 13) Raise the dusthood (switch G). 14) Place the starter rod with a coupling into the centralizer. Close the centralizer onto the coupling (switch E).

1) Place the HP / Dust collector switch on posi- tion J1 (middle). 15) Feed the drifter down to the centralizer end of the drill guide (feed lever in B3 direction). 2) Select the manual mode (mode selector in S0 position). 3) Check the indicator (L) is alight. If not, depress M2 or M5 button to rotate the carousel. 16) Screw the drifter shank into the coupling (rod changer lever in K2 direction). Release the button when the indicator (L) is alight. 17) Open the centralizer (switch E). Feed the drifter back (feed lever in B2 direction) until the cou- pling is above the centralizer. Close the centralizer (switch E).

4) Swing the rod clamp arms towards the guide (rod changer lever in K1 direction). 18) Feed the drifter back (feed lever in B4 direc- tion) until the rod threads are bellow the dust hood. Screw on a bit to the rod. Retract the drifter so that the bit enters inside the dusthood (feed lever in B2 direc- tion). 5) Open the rod clamps (depress M4 button). 6) Mount a coupling on the rod to be loaded. Place the rod into the rod clamps. 7) Close the rod clamps onto the rod (depress M1 button). 8) Swing the rod clamp arms into the carousel (rod changer lever in K3 position). 9) Open the rod clamps (depress M4 button). 10) Depress M5 button to rotate the carousel.

Release the button when the indicator (L) is alight. 7-46