TM 5-3805-280-10 Starting operation START UP Make a walk–around inspection before mounting the machine and starting the engine. Look around and under the machine for loose bolts, broken or worn parts. Have the machine repaired before starting. Check engine oil and coolant, hydraulic and compressor oil levels. Refill if necessary. Check the emergency stop selector is placed on CPA position. CPA Check all electric cables of the remote con- trol are properly connected. Check excavator safety switch is in lock position. Start engine and warm by carrier manufac- turer handbook. Check compressor is off. Set the guide in toe holes drilling position, to inspect the guide chains and wire rope.
(#) Set engine R.P.M mode. (#) refer to maintenance section for further infor- mation. 7-49