John Deere 230LCR, 230LCRD — CHAPTER 7

TM 5-3805-280-10 Rod changer REMOVING A ROD (AUTO MODE S2) the carousel is properly positioned i.e. a rod housing is in front of the opening of the rod catcher (the indicator L is then alight). Make sure : note : If during this sequence, the drifter shank or the upper coupling uncouples, returns to point 5). the rod clamp arms are swung into the rod changer. 7) After the rod has been disconnected from the bottom coupling and is high enough to enter into the carousel, close the clamps onto the rod : the drifter shank unscrews from the top coupling (depress M1 button while changer lever in K4 direction). the rod clamps are closed. the mode selector is on S2 position.

1) While drilling the end of the last rod and if the drifter has not reached its front end position, start to break loose the drifter shank (depress the thread loosening button H and pull back the drifter control lever in C2 direction to reverse the rotation). 8) After the drifter shank has been discon- nected from the top coupling swing the rod into the carousel (changer lever in K3 direction). Stop drilling. note : If the rod abuts against the rod holder plate, 2) Feed the drifter back (feed lever in B4 direc- tion) until the bottom coupling is in the centralizer. – swing the rod toward the guide (changer lever in K1 direction).

Close the centralizer onto the coupling (switch E) – screw the drifter shank into the coupling (changer lever in K2 direction). – depress M4 button to open the clamps and keeping M4 button depressed, adjust the position of the rod by acting on the feed control lever. 3) Break loose the rod (depress the thread loosening button H and pull back the drifter control lever in C2 direction to reverse the rotation). The rota- tion of the rod must be visible when looking at the con- nection, air flows from the connection. – swing the rod into the carousel (changer lever in K3 direction). Stop air flushing (switch F).

9) Feed the drifter down to the centralizer end of the drill guide (feed lever in B3 direction). 4) Swing the rod changer lever in K1 direction. Hold the position for 1 second (the rod clamps open, the carousel rotate, the rod clamp arms swing towards the guide and the clamps close onto the rod). 10) Screw the drifter shank into the coupling (rod changer lever in K2 direction). 5) Tighten the upper coupling onto the rod (rod changer lever in K2 direction, hold the position for few seconds). 11) Perform steps 2 through 10 to remove more rod. 6) Unscrew the rod from the bottom coupling (rod changer lever in K4 direction). 7-48