John Deere 230LCR, 230LCRD — CHAPTER 7

TM 5-3805-280-10 WATER POCKETS As soon as the operator observes water going into the dust collector, shut it down. If shutdown was immediate and operator is sure that no water has entered the dust collector, drilling may be resumed until dust smoke is observed coming from the hole. Then the dust collector can be started again. If water has entered the dust collector, or in case of doubt, stop drilling and retract the drifter (do not stay in the water pocket). Wait 5 to 10 minutes with the dust collector running and air flushing so as to dry the filter cartridges. Then do 10 cycles of stopping, flushing and starting the dust collector again to clean the dry mud from the filter cartridge.

Restart drilling with the dust collector shut off as long as no dust smoke is coming from the hole. Mud inside the hood and plastic hose has to be removed manually. ROD CHANGING Refer to Changing a Rod. SHUT DOWN Switch off drill and compressor. Move carrier to park site. Position CPA vertical. mast base on ground. Position excavator safety switch to lock. — Idle down engine to manufacturer specifications. 7-53