John Deere 230LCR, 230LCRD — CHAPTER 7

TM 5-3805-280-10 Operating the Machine LOWER BOOM WITH ENGINE STOPPED When an engine stops during operation, the boom cannot be lowered using the pilot controller because there is no pilot pressure oil to move the boom valve spool or to unlatch the boom load lowering valves. X9811 –UN–23AUG88 CAUTION: Prevent possible injury from unexpected machine movement. Clear all persons from the area before lowering the boom with the engine stopped. To avoid injury from escaping fluid under pressure, stop engine and relieve the pressure in the system before disconnecting or connecting hydraulic or other lines. Tighten all connections before applying pressure. 1. Loosen jam nut on relief valve (A).

Back off relief valve set screw, counting number of turns, until boom starts to lower slowly. 2. After bucket is on ground, reset relief valve (A) by turning set screw clockwise the same number of turns noted in step 1 and lock jam nut. T127544 –UN–19JAN00 A—Relief Valve B—Boom Cylinder CED,OUOEBAS,2 –19–19JAN00–1/1 7-54