TM 5-3805-280-10 Maintenance—As Required 5. Measure distance (A) at middle track roller from bottom of track frame to top surface of track shoe. Normal Ground Condition—Specification Track Sag 300—335 mm (11-13/16—13-3/16 in.) ............................................................................. T7869AP –UN–22OCT92 For general information on track sag, see Maintenance chapter. TX,55,DH5447 –19–04MAR97–2/2 ADJUSTING TRACK SAG IMPORTANT: Prevent possible damage to track components. DO NOT use the grease fitting on the track adjusting cylinder for lubrication. Use this fitting ONLY for track adjustment.
T7396DZ –UN–28NOV90 To tighten track, connect a grease gun to grease fitting (A) (located through access hole (D) in track frame. Add grease until sag is within recommended limits. CAUTION: Prevent possible injury from high pressure grease. Do not remove grease fitting (A) from nut (B). To loosen, slowly turn nut (B) counterclockwise; grease will escape through the bleed hole (C). T7869AQ –UN–22OCT92 Nut—Specification Torque 147 (108 lb-ft) ......................................................................... When amount of track sag is satisfactory, turn nut clockwise to tighten. A—Grease Fitting B—Nut C—Bleed Hole D—Access Hole TX,55,FF2991 –19–29OCT92–1/1 11-6