TM 5-3805-280-10 Maintenance—Every 10 Hours or Daily CHECK HYDRAULIC OIL LEVEL IMPORTANT: Prevent damage to hydraulic system components. DO NOT run engine without oil in hydraulic tank. 1. Park machine on a level surface. T6811AI –UN–18OCT88 2. Position machine with arm cylinder fully retracted and bucket cylinder fully extended. 3. Lower bucket to the ground. 4. Turn auto-idle switch off. IMPORTANT: Turbocharger may be damaged if engine is not properly shut down. 5. Run engine with engine rpm dial at 1/3 position without load for 2 minutes. 6. Move engine rpm dial to slow idle position. 7. Turn key switch to OFF. Remove key from switch. 8.
Attach a Not Operate’ tag on the right control lever. 9. Pull pilot control shut-off lever to locked position. TX,60,DH5096 –19–08JUL96–1/5 10. Check oil level window (A) on hydraulic tank. Oil must be between marks on window. If necessary, add oil. (See Fuels and Lubricants chapter.) To add oil: T102301 –UN–30JUL96 Continued on next page TX,60,DH5096 –19–08JUL96–2/5 12-3