John Deere 230LCR, 230LCRD — CHAPTER 15

TM 5-3805-280-10 Maintenance—Every 250 Hours 10. Remove cover from under the engine. Remove drain plug (A) from bottom of engine oil pan, or open drain valve on side of engine oil pan. Allow oil to drain into a container. Dispose of waste oil properly. 11. Turn filter (B) counterclockwise to remove. Clean mounting surface on base. T120417 –UN–25MAR99 12. Apply thin film of oil to rubber gasket of new filter. 13. Install new filter. Turn filter clockwise by hand until gasket touches mounting surface. 14. Tighten filter 1/2—3/4 turn more. 15. Install drain plug or close drain valve. 16. Remove fill cap (C).

Oil—Specification Capacity with Filter Change 19 L (20 qt) .................................................... 17. Fill engine with oil. (See Fuels and Lubricants chapter.) 18. Install fill cap. 19. Start engine. Engine oil pressure indicator on monitor must go out within 15-20 seconds. If not, stop engine immediately and find the cause. T108262B –UN–27MAR97 20. Stop engine. Check oil level. 21. Check for any leakage at filter. Tighten filter just enough to stop leakage. 22. Install cover from under the engine. A—Drain Hose B—Filter C—Fill Cap TX,OUOE042,26 –19–08MAR99–2/2 14-4